Our inspection goes beyond a simple visual check. Our senior technicians perform a full technical audit:
- Compressor Health Check: Measuring the amperage and vibration levels of the compressor to predict potential failure
- Gas Pressure Analysis: Checking for low refrigerant levels that cause the motor to work overtime.
- Thermostat & Sensor Calibration: Testing the internal sensors to ensure the cabin stays at the food-safe temperature.
- Inverter Board Diagnostic: For modern models, we scan the PCB for error codes or signs of electrical wear.
- Condenser Coil Inspection: Checking for dust build-up that prevents heat dissipation and wastes electricity.
- Gasket & Seal Testing: A "leak test" on the door magnets to ensure no cold air is escaping.
- Drainage & Defrost Audit: Checking the heater and drain lines to prevent internal water leakage or ice build-up.