AC Care · Care guide
Split AC Installation Checklist for Bangladesh Apartments
Technician Technical Team · 17 November 2026

A good AC can perform badly if it's installed badly. Use this checklist to make sure your new split AC is installed safely and correctly.
A new split AC is a significant investment, but many cooling problems we see in Dhaka apartments are not caused by the AC itself. They come from poor installation. Water leaks, weak cooling, noise and early compressor failure can all start on installation day.
Use this checklist to make sure your AC is installed properly, whether it goes on a balcony, an outside wall or a rooftop.
Choose the right place for the indoor unit
The indoor unit should be mounted on a solid wall, high enough for air to circulate across the room, and away from direct sunlight and heat sources such as a kitchen. Leave enough space above and around the unit for airflow and for future cleaning.
Give the outdoor unit room to breathe
The outdoor unit releases heat. If it is boxed into a tight grill cage, placed in a closed balcony corner or blocked by stored items, hot air recirculates and cooling performance drops. Keep the area in front of and behind the fan clear, and make sure the unit is on a strong bracket or a level base.
Keep piping as short and neat as practical
Follow the manufacturer's guidance on pipe length and height difference between the two units. Copper pipes should be properly insulated, with no sharp bends or crushed sections. Long or poorly routed piping reduces efficiency.
Vacuuming is not optional
Before the refrigerant is released into the new pipes, the system must be vacuumed with a vacuum pump to remove air and moisture. Skipping this step can reduce cooling and damage the compressor over time. Ask your installer to confirm this is done.
Check for leaks at every joint
Flare joints must be made with the correct tools and tightened properly. A good installer checks every joint for leaks before finishing the job.
Get the drainage right
The drain pipe must slope downward all the way to its outlet, with no rises or sags. The outlet should drain somewhere suitable, not onto a neighbour's balcony or a walkway.
Safe wiring and earthing
The AC should have suitable wiring, a correctly rated circuit breaker and proper earthing. Avoid running an AC from an extension board. If your building's wiring is old, have it checked before installation.
Safety for balcony and rooftop work
Installing an outdoor unit on an outside wall or a high balcony is work at height. It should be done by trained technicians using safety equipment. Never allow anyone to lean out unsecured to fix a bracket.
Test before the technician leaves
Once installed, the technician should run the AC, check that cold air is coming out, that water drains outside, that the outdoor unit runs smoothly, and that there are no unusual noises or vibration.
Book a verified technician
Technician sends verified, trained technicians to homes and offices across our service areas. Book online or call our hotline, choose a time slot that suits you, and the technician will explain the problem and the cost before any repair work begins. Every service visit is backed by our service warranty.
Keep reading

AC Water Leaking From the Indoor Unit? 7 Causes and How to Fix Them

Microwave Oven Not Heating? 10 Common Problems, Causes, and Solutions
